connextions gay dating site - Updating etc fstab

) and it has already been removed from Debian repositories.

When a Red Hat Enterprise Linux system is newly-installed, all the disk partitions defined and/or created during the installation are configured to be automatically mounted whenever the system boots.

However, what happens when additional disk drives are added to a system after the installation is done? This file is used to control what file systems are mounted when the system boots, as well as to supply default values for other file systems that may be mounted manually from time to time.

The answer is "nothing" because the system was not configured to mount them automatically.

The second column should contain the mount point for the new partition, and the next column should be the file system type (for example, ext3 or swap).

You would normally have to reboot your Linux system, after editing this file.

The system has a variety of mount options in use across eight partitions, including several bind mounts.Following from the syntax you gave, the new entry should be No it should be /dev/sdb1 if it is the only partition on the disk.you can check with "sudo fdisk -l" this will show you the disk /dev/sdb and then its partitions so /dev/sdb1 will be your ext4, and the mount point would be "/mydata" which would mean it was a folder that already exists on the root of the drive called mydata.contains the necessary information to automate the process of mounting partitions.In a nutshell, mounting is the process where a raw (physical) partition is prepared for access and assigned a location on the file system tree (or mount point). Auto will attempt to automatically detect the file system of the target file system and in general works well.I'm testing options and their effect on the image I'm working on. options like # # /etc/fstab # UUID=e6ca80cd / ext4 noatime,nobarrier 1 1 UUID=a327d315 /boot ext4 defaults 1 2 UUID=333ada18 /home ext4 noatime,nobarrier,nodev 1 2 UUID=7835718b /tmp ext4 nodev,nosuid,noexec 1 2 UUID=4dd2e9d4 /usr ext4 defaults 1 2 UUID=c274f65f /var ext4 noatime,nobarrier 1 2 UUID=5b5941e0 /var/log ext4 defaults 1 2 UUID=3645951a /var/log/audit ext4 defaults 1 2 UUID=3213123c /vol1 xfs noatime,logbufs=8,nobarrier 1 2 UUID=1ee1c070 swap swap defaults 0 0 # Bind mount for /tmp /tmp /var/tmp none bind 0 0 tmpfs /dev/shm tmpfs nodev,nosuid,noexec 0 0 devpts /dev/pts devpts gid=5,mode=620 0 0 sysfs /sys sysfs defaults 0 0 proc /proc proc defaults 0 0 (re)mountpoint.

Tags: , ,